Saginaw Street and Strip

On the push button i have a power wire to 1 terminal, starter solenoid wire to the other terminal. On a toggle switch i have a power wire on 1 terminal and the 12v from my msd on the other terminal, the car starts but does not shut off ??? Any info anyone ???

well since no one else posted yet,I'll tell you how I did it on mine.
I took a wire off from the + or - side of the coil.
if you take the - side just take the wire and put it to a switch,from the switch to a good ground.
this way when you flip the switch it breaks the ground .

if going from the + side,take a wire and run it to the switch,from there to the + side of coil,
and when you flip the switch it loses power to the coil,shutting engine down.

Hope that this helps you out.
hows the car comming along?

Just found this message. if you have alt on this car you are getting a feed back thur it. if you go to MSD web site I think it's in there how to wire it up hope this helps.